I've been real lucky so far, for the most part I have just been unloading the boys Jr. and running it. Last week, however, on the first pass it started dumping alcohol out the little black hoses coming from the carb (Mukini 28). My experience in the past was that there was some crud in there and the needle and seat were stuck open. I drained the carb and blew a little air through the fuel inlet and refired it...no leaking. Went to make another run and it went about 30 feet and died. I brought it back, refired first time, seemed fine, took it back up and it started pouring fuel out the hoses again. We were running the big car as well so I just loaded the thing. I have taken it all apart, there was some gunk in it, think I got some bad fuel (dirty) from the track. I have cleaned it all real good, blew out all the differant holes. Now how/where do I set the float level. I have one float that was tweeked a bit, I assume you bend the floats to a certain level, but dont know were. Any help on setting that, and anything to look for when cleaning these things out would be great. I have to admit, running the Enderle injection for about 12 years has rendered me "carb illiterate".
Thanks for your help,

Turn upside down adjust float to level when looking at it. Put a good fuel filter on it. A stainless or nylon element (no paper). Hope this helps